Open source · Home Assistant

Orkli Termowifi for Home Assistant

An unofficial Home Assistant custom integration for Orkli Termowifi controllers. It exposes every room of the installation as a climate entity, so you can control your heating and cooling from Home Assistant, locally.

Source on GitHub Add to HACS

What it does

Each room exposed by the Termowifi device becomes a climate entity.
Supports the heat, cool and off modes, and setting the target temperature.
Reports the current temperature and humidity when the device provides them.
Registers the device in the Home Assistant device registry (manufacturer: Orkli).
Set up from the UI with a config flow: you only provide the IP address and port of the controller.

Install

In HACS go to Integrations, open the menu and choose Custom repositories.
Add github.com/diegogd/orkli-termowifi-hass-integration with the category Integration.
Install Orkli Termowifi and restart Home Assistant.
Add the integration from Settings and enter the controller IP address and port.

Good to know

This integration is unofficial and provided as is. It was tested with a single installation, so it may need adjustments for other Termowifi firmware versions or network setups. Bug reports are welcome on GitHub; please include your Home Assistant version and debug logs.